Extreme EZS Password:
This field Displays the SSID of the EZS.
This field displays the EZS Sonder Hash. Sonder Hash can be called different names depending on the tool manufacturer. It is good to understand that Sonder/Special and Service Hash are all same, only different terminology. Same goes for Dealer Password and Erase Password. From the Sonder you can calculate the Dealer Password needed to Renew EZS. You can calculate the “Dealer Password” using the Extreme MB tool software.
Password: = This is the actual “True” EZS Password calculated and checked by our software, because we check the Password before it is displayed inside this field you can be 100% sure that it is a match with the EZS.
4. Enc. Pass
Enc.Pass: = Encrypted Password. When we see this Enc. Pass, this means that Password reading via IR is not supported on this EZS. The EZS has returned an encrypted response, we can only use this encrypted response to verify the true password if it is known.
5. Go Button
Pressing the “GO” button will start the process of reading the EZS Password Via the IR Portal. This can take up to 3 minutes to complete. HC12 types are usually finished within 50 seconds, whereas HC908 types can take up to 3 minutes.
**Read Password direct from EZS via IR. Support Old Motorola EZS with MCU’s HC908 and HC12 inside EG: Some W203, W463, W209, W211, W215. Not support HC05, ST12 or ZGW types.. Here is a list of tested Part Numbers: 2035450108, 2035450308, 2035450508, 2035450608, 2095450508, 2115450608, 2115451008, 2155450208, 2155450408